| 1. |
- Vithanage, Dimali, et al.
(författare)
-
Charge carrier dynamics of polymer: Fullerene blends: From geminate to non-geminate recombination
- 2014
-
Ingår i: Advanced Energy Materials. - : Wiley. - 1614-6840 .- 1614-6832. ; 4:8
-
Tidskriftsartikel (refereegranskat)abstract
- The charge carrier dynamics of a new polymer-fullerene blend are examined on the femtosecond to the millisecond time scale. The full time range is globally fitted using a chemical reaction rate model that includes all key processes, charge generation, energy transfer, charge separation, and recombination, over the full 12 orders of magnitude in time and a factor of 33 in light intensity. Particular attention is paid to the charge recombination processes and it is found that they are highly material specific. Comparison of the dynamics to those of a previously studied polymer:fullerene blend reveals that while for one blend the recombination dynamics are mainly controlled by geminate recombination, the charge recombination in the presently studied polymer:fullerene blend are entirely controlled by non-geminate electron-hole recombination. Carrier density dependence of the non-geminate recombination rate is analyzed and a correlated disorder model of site energies is proposed to explain the observed dependency. © 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.
|
|
| 2. |
- George, Zandra, 1985, et al.
(författare)
-
Two-in-one : Cathode modification and improved solar cell blend stability through addition of modified fullerenes
- 2016
-
Ingår i: Journal of Materials Chemistry A. - : Royal Society of Chemistry (RSC). - 2050-7488 .- 2050-7496. ; 4:7, s. 2663-2669
-
Tidskriftsartikel (refereegranskat)abstract
- The synthesis of dual purpose modified fullerenes with pyridine-as well as amine-functional groups is reported. Addition of these fullerenes to a polymer : fullerene bulk-heterojunction blend based on a thiophene-quinoxaline donor polymer is found to modify the active layer/cathode interface of inverted solar cells (glass/ITO/active layer/MoO3/Al). In particular the open-circuit voltage of devices is increased from 0.1 V to about 0.7 V, which results in a drastic rise in photovoltaic performance with a power conversion efficiency of up to 3%. At the same time, presence of the functionalised fullerene additives prevents the detrimental formation of micrometre-sized fullerene crystals upon annealing at 140 degrees C. As a result, the device performance is retained, which promises significantly increased thermal stability of the bulk-heterojunction blend nanostructure.
|
|
| 3. |
- Wang, Chuanfei, et al.
(författare)
-
Low Band Gap Polymer Solar Cells With Minimal Voltage Losses
- 2016
-
Ingår i: Advanced Energy Materials. - : Wiley. - 1614-6832 .- 1614-6840. ; 6:18
-
Tidskriftsartikel (refereegranskat)abstract
- One of the factors limiting the performance of organic solar cells (OSCs) is their large energy losses (E loss) in the conversion from photons to electrons, typically believed to be around 0.6 eV and often higher than those of inorganic solar cells. In this work, a novel low band gap polymer PIDTT-TID with a optical gap of 1.49 eV is synthesized and used as the donor combined with PC71BM in solar cells. These solar cells attain a good power conversion efficiency of 6.7% with a high open-circuit voltage of 1.0 V, leading to the E loss as low as 0.49 eV. A systematic study indicates that the driving force in this donor and acceptor system is sufficient for charge generation with the low E loss. This work pushes the minimal E loss of OSCs down to 0.49 eV, approaching the values of some inorganic and hybrid solar cells. It indicates the potential for further enhancement of the performance of OSCs by improving their V oc since the E loss can be minimized.
|
|
| 4. |
- Diaz de Zerio Mendaza, Amaia, 1986, et al.
(författare)
-
High-Entropy Mixtures of Pristine Fullerenes for Solution-Processed Transistors and Solar Cells
- 2015
-
Ingår i: Advanced Materials. - : Wiley. - 0935-9648 .- 1521-4095. ; 27:45, s. 7325-7331
-
Tidskriftsartikel (refereegranskat)abstract
- The solubility of pristine fullerenes can be enhanced by mixing C60 and C70 due to the associated increase in configurational entropy. This "entropic dissolution" allows the preparation of field-effect transistors with an electron mobility of 1 cm2 V-1 s-1 and polymer solar cells with a highly reproducible power-conversion efficiency of 6%, as well as a thermally stable active layer.
|
|
| 5. |
- Li, Wei, et al.
(författare)
-
One-Step Synthesis of Precursor Oligomers for Organic Photovoltaics: A Comparative Study between Polymers and Small Molecules
- 2015
-
Ingår i: ACS Applied Materials and Interfaces. - : American Chemical Society (ACS). - 1944-8244 .- 1944-8252. ; 7:49, s. 27106-27114
-
Tidskriftsartikel (refereegranskat)abstract
- Two series of oligomers TQ and rhodanine end-capped TQ-DR were synthesized using a facile one-step method. Their optical, electrical, and thermal properties and photovoltaic performances were systematically investigated and compared. The TQ series of oligomers were found to be amorphous, whereas the TQ-DR series are semicrystalline. For the TQ oligomers, the results obtained in solar cells show that as the chain length of the oligomers increases, an increase in power conversion efficiency (PCE) is obtained. However, when introducing 3-ethylrhodanine into the TQ oligomers as end groups, the PCE of the TQ-DR series of oligomers decreases as the chain length increases. Moreover, the TQ-DR series of oligomers give much higher performances compared to the original amorphous TQ series of oligomers owing to the improved extinction coefficient (epsilon) and crystallinity afforded by the rhodanine. In particular, the highly crystalline oligomer TQ5-DR, which has the shortest conjugation length shows a high hole mobility of 0.034 cm(2) V-1 s(-1) and a high PCE of 3.14%, which is the highest efficiency out of all of the six oligomers. The structure-property correlations for all of the oligomers and the TQ1 polymer demonstrate that structural control of enhanced intermolecular interactions and crystallinity is a key for small molecules/oligomers to achieve high mobilities, which is an essential requirement for use in OPVs.
|
|
| 6. |
- Li, Zhaojun, 1989, et al.
(författare)
-
High Performance All-Polymer Solar Cells by Synergistic Effects of Fine-Tuned Crystallinity and Solvent Annealing.
- 2016
-
Ingår i: Journal of the American Chemical Society. - : American Chemical Society (ACS). - 1520-5126 .- 0002-7863. ; 138:34, s. 10935-44
-
Tidskriftsartikel (refereegranskat)abstract
- Growing interests have been devoted to the design of polymer acceptors as potential replacement for fullerene derivatives for high-performance all polymer solar cells (all-PSCs). One key factor that is limiting the efficiency of all-PSCs is the low fill factor (FF) (normally
|
|
| 7. |
- Ma, Zaifei, et al.
(författare)
-
A Facile Method to Enhance Photovoltaic Performance of Benzodithiophene-Isoindigo Polymers by Inserting Bithiophene Spacer
- 2014
-
Ingår i: Advanced Energy Materials. - : Wiley. - 1614-6840 .- 1614-6832. ; 4:6, s. Art. no. 1301455-
-
Tidskriftsartikel (refereegranskat)abstract
- This study describes the synthesis and characterization of four polymers based on benzo[1,2-b:4,5-b']dithiophene (BDT) and isoindigo with zero, one, two, and three thiophene spacer groups. Results have demonstrated that the use of bithiophene as a spacer unit improves the geometry of the polymer chain, making it planar, and hence, potentially enhanced π- π stacking occurs. Due to favorable interaction of the polymer chains, enhanced absorption coefficient, and optimal morphology, PBDT-BTI, which possesses bithiophene as a spacer, revealed high current and fill factor leading to a power conversion efficiency of 7.3% in devices, making this polymer the best performing isoindigo-based material in polymer solar cells (PSCs). Also, PBDT-BTI could still maintain efficiency of over 6% with the active layer thickness of 270 nm, making it a potential candidate for a material in printed PSCs. These results demonstrate that the use of thiophene spacers in D-A polymers could be an important design strategy to produce high-performance PSCs.
|
|
| 8. |
- Qian, D. P., et al.
(författare)
-
Modulating molecular aggregation by facile heteroatom substitution of diketopyrrolopyrrole based small molecules for efficient organic solar cells
- 2015
-
Ingår i: Journal of Materials Chemistry A. - : Royal Society of Chemistry (RSC). - 2050-7488 .- 2050-7496. ; 3:48, s. 24349-24357
-
Tidskriftsartikel (refereegranskat)abstract
- In conjugated polymers and small molecules of organic solar cells, aggregation induced by intermolecular interactions governs the performance of photovoltaics. However, little attention has been paid to the connection between molecular structure and aggregation within solar cells based on soluble small molecules. Here we demonstrate modulation of intermolecular aggregation of two synthesized molecules through heteroatom substitution to develop an understanding of the role of aggregation in conjugated molecules. Molecule 1 (M1) based on 2-ethylhexyloxy-benzene substituted benzo[1,2-b:4,5-b']dithiophene (BDTP) and diketopyrrolopyrrole (DPP) displays strong aggregation in commonly used organic solvents, which is reduced in molecule 2 (M2) by facile oxygen atom substitution on the BDTP unit confirmed by absorption spectroscopy and optical microscopy, while it successfully maintains molecular planarity and favorable charge transport characteristics. Solar cells based on M2 exhibit more than double the photocurrent of devices based on M1 and yield a power conversion efficiency of 5.5%. A systematic investigation of molecular conformation, optoelectronic properties, molecular packing and crystallinity as well as film morphology reveals structure dependent aggregation responsible for the performance difference between the two conjugated molecules.
|
|
| 9. |
|
|
| 10. |
- Wang, Chuanfei, 1986-, et al.
(författare)
-
Ternary Organic Solar Cells with Minimum Voltage Losses
- 2017
-
Ingår i: Advanced Energy Materials. - : Wiley. - 1614-6832 .- 1614-6840. ; 7:21
-
Tidskriftsartikel (refereegranskat)abstract
- A new strategy for designing ternary solar cells is reported in this paper. A low-bandgap polymer named PTB7-Th and a high-bandgap polymer named PBDTTS-FTAZ sharing the same bulk ionization potential and interface positive integer charge transfer energy while featuring complementary absorption spectra are selected. They are used to fabricate efficient ternary solar cells, where the hole can be transported freely between the two donor polymers and collected by the electrode as in one broadband low bandgap polymer. Furthermore, the fullerene acceptor is chosen so that the energy of the positive integer charge transfer state of the two donor polymers is equal to the energy of negative integer charge transfer state of the fullerene, enabling enhanced dissociation of all polymer donor and fullerene acceptor excitons and suppressed bimolecular and trap assistant recombination. The two donor polymers feature good miscibility and energy transfer from high-bandgap polymer of PBDTTS-FTAZ to low-bandgap polymer of PTB7-Th, which contribute to enhanced performance of the ternary solar cell.
|
|
